Low performance is allowed for the printer to print a barcode. The readable range (reading depth) for a barcode is widened. High performance is required for the printer to print a barcode.(laser printer, thermal transfer printer) If the narrow width is large The size of a barcode becomes large. The readable range (reading depth) for a barcode is narrowed. A barcode with many digits can be printed in a given space. Barcode Input options specify the device hardware to use for scanning and the decoders to be applied on the acquired data before sending it for processing. One Point If the narrow width is small: The size of a barcode becomes small. Back-to-Basics: An Introduction to Barcode Reading and Symbologies. Advance your knowledge of barcode reading today Download Now. Narrow bar width is also named "minimum element width". Choose the type of code youd like to make, enter your information, and generate a downloadable barcode and HTML code for free. The width of a narrow bar is a key for selecting a barcode reader. The following ratio is normally recommended for preparing a barcode. If the ratio of narrow and wide is out of the range above, the barcode reader may perform unstable readings.įor preparing a barcode, careful attention shall be made to this ratio. Narrow and wide widths are determined at the following ratio: It is recommended to keep the height greater than 15 % of the barcode length. If the barcode is not high enough, the laser may deviate from the barcode, causing unstable readings. It is recommended to make the barcode as high as the printer permits. A barcode reader or barcode scanner is an optical scanner that can read printed barcodes, decode the data contained in the barcode to a computer. The Barcode Information & Tips site offers information on the standards, basic principles, and reading know-how related to barcodes and 2D codes. If the barcode length, includinng quiet zones, does not fit in the scan width, the barcode reader cannot scan the data. Barcode Printers, Mobile Computers, Elo and Planar LCD Touch Screens. This page introduces five typical barcode types: EAN, CODE 39, ITF, NW-7, and CODE 128. It is appended directly after the barcode data.īarcode length defines the total length including the right and left quiet zones. Check digitĪ numeric value calculated to check for read error. The drawing above shows that the data of “012” is demonstrated, with the bar patterns representing 0, 1, and 2 being arranged respectively from the left. (EAN and ITF use, instead of a character, a bar pattern which indicates the start/end of the data.) Data (message)īar patterns representing the data (numerical characters, alphabet, etc.) are arranged from left. CODE 39 uses “*” and CODABAR uses “a”,“b”,“c” and “d”. Start/stop character varies depending on the type of the barcode. Start/stop characterĬharacter to indicate start or end of the data. Unless the quiet zones are wide enough, it becomes unstable for the barcode reader to scan the barcode data. (See here for narrow bar width.) One Point If the margin is not wide enough, the barcode reader cannot scan the barcode data.īoth the right and left margins should be at least 10 times as wide as the narrow bar width (minimum element width). The right and left ends of the barcode symbol.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |